Subaru 2009 Tribeca User Manual download pdf (Page 45)

! Adjusting the front seat shoulder

belt anchor height

The shoulder belt anchor height should be

adjusted to the position best suited for the

driver/front passenger. Always adjust the

anchor height so that the shoulder belt

passes over the middle of the shoulder

without touching the neck.

To raise:

Slide the anchor up.

To lower:

Push the release button and slide the

anchor down.

Pull down on the anchor to make sure that

it is locked in place.

WARNING

When wearing the seatbelts, make

sure the shoulder portion of the

webbing does not pass over your

neck. If it does, adjust the seatbelt

anchor to a lower position. Placing

the shoulder belt over the neck may

result in neck injury during sudden

braking or in a collision.

! Unfastening the seatbelt

Push the button on the buckle.

Before closing the door, make sure that

the belts are retracted properly to avoid

catching the belt webbing in the door.

! Rear seatbelts (5-seater models)/

Second-row seatbelts (7-seater

models) – excluding center seatbelt

1. Sit well back in the seat.

2. Pick up the tongue plate and pull the

belt out slowly. Do not let it get twisted. If

the belt stops before reaching the buckle,

return the belt slightly and pull it out more

slowly. If the belt still cannot be unlocked,

let the belt retract slightly after giving a

strong pull on it, then pull it out slowly

again.

3. Insert the tongue plate into the buckle

until you hear a click.

Seat, seatbelt and SRS airbags 1-21

– CONTINUED –

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 410 411

Comments to this Manuals

No comments