Subaru 2009 Tribeca User Manual download pdf (Page 110)

2-14 Keys and doors

6. When you have finished entering the

number, push the “

” side of the locking

switch within 5 seconds.

NOTE

. An electronic tone will sound.

. If you push the “

” side of the

lockingswitchwhenmorethan5

seconds have passed, an error will

occur. In this event, perform the proce-

dure again beginning with part 4. If an

error occurs six times, perform the

procedure again starting with part 3.

7. Perform parts 5 and 6 of the procedure

for each of the remaining digits of the

transmitter code beginning with the sec-

ond digit (count ing from the left) and

finishing with the eighth digit.

NOTE

. When you finish entering the eighth

digit, an electronic tone will sound for

30 seconds.

. If the interval between one push of

the switch and the next exceeds 5

seconds, an error will occur. In this

event, perform the procedure again

beginning with part 4. If an error occurs

six times, perform the procedure again

starting with part 3.

8. Before the electronic tone stops

sounding, use the powe r door locking

switch to reenter the transmitter code

beginning with the leftmost digit.

NOTE

If you do not start entering the number

using the lock knob before the electro-

nic tone stops sounding, an error will

occur. In this event, perform the proce-

dure again beginning with part 3.

9. When you have finished entering the

code a second time, an electronic tone will

sound for 1 second and automatic door

locking and unlocking operation will take

place once to indicate completion of

registration, provided the code entered

the second time is identical to that entered

the first time.

NOTE

If the code entered the second time is

not identical to the code entered the

first time, an error will occur. In this

event, perform the procedure again

beginning with part 5. If an error occurs

five times, perform the procedure again

starting with part 3.

10. If you wish to program another trans-

mitter code into the system (up to four

transmitter codes can be programmed into

the system), perform the procedure begin-

ning with part 4. When you have finished

programming all of the necessary trans-

mitter codes into the system, remove the

key from the ignition switch.

11. Test every registered transmitter to

confirm correct operation.

! Deleting old transmitter codes

The control unit of the remote keyless

entry system has four memory locations to

store transmitter codes, giving it the ability

to operate with up to four transmitters.

When you lose a transmitter, the lost

transmitter’s code remains in the memory.

For security reasons, lost transmitter

codes should be deleted from the mem-

ory.

To delete old transmitter codes, program

four transmitter codes into the system. If

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 410 411

Comments to this Manuals

No comments