Subaru 2009 Tribeca User Manual download pdf (Page 142)

3-20 Instruments and controls

section in chapter 2.

If the indicator light does not flash, it may

indicate that immobilizer system may be

malfunctioning. Contact your nearest

SUBARU dealer immediately.

In the event that an unauthorized key (for

example, an unauthorized duplicate) is

used, the security indicator light illumi-

nates.

& SPORT mode indicator

light

This light illuminates when the ignition

switch is turned to the “ON” position and

turns off after the engine has started.

When the selector lever is moved to the

manual gate, the SPORT mode is se-

lected and the indicator light illuminates.

Refer to the “Automatic transmission”

section in chapter 7.

& Selector lever/Gear position

indicator

The selector lever/gear position indicator

shows the position of the selector lever.

When manual mode is selected, the gear

position indicator shows the current gear

position and the upshift/downshift indica-

tor illuminates. Refer to the “Automatic

transmission” section in chapter 7.

& Turn signal indicator

lights

These lights show the operation of the turn

signal or lane change signal.

If the indicator lights do not blink or blink

rapidly, the turn signal bulb may be burned

out. Replace the bulb as soon as possible.

Refer to the “Replacing bulbs” section in

chapter 11.

& High beam indicator

light

This light shows that the headlights are in

the high beam mode.

This indicator light also illuminates when

the headlight flasher is operated.

& Cruise control indica-

tor light

The cruise control indicator light illumi-

nates when the ignition switch is turned to

the “ON ” position and turns off after

approximately 3 seconds.

This light illuminates when the “CRUISE”

main switch is pressed.

NOTE

. If you move the cruise control lever

or press the main switch button while

turning the ignition switch “ON”, the

cruise control function is deactivated

and the cruise control indicator light

flashes. To reactivate the cruise control

function, turn the ignition switch back

to the “Acc” or “LOCK” position, and

then turn it again to the “ON” position.

. If this indicator light and the CHECK

ENGINE warning light/malfunction in-

dicator lamp flash simultaneously dur-

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 410 411

Comments to this Manuals

No comments