Subaru 2009 Tribeca User Manual download pdf (Page 246)

7-10 Starting and operating

transmitter within a few seconds immedi-

ately following remote engine start shut-

down.

& Pre-heating or pre-cooling

the interior of the vehicle

Before exiting the vehicle, set the tem-

perature controls to the desired setting

and operation. After the system starts the

vehicle, the heater or air-conditioning will

activate and heat or cool the interior to

your setting.

& Service mode

In service mode, the remote start function

is temporarily disabled to prevent the

system from unexpectedly starting the

engine while being serviced.

! To engage the service mode

Turn the ignition switch to the “ON”

position, depress and hold the brake pedal

then, press and release the “

” button on

the remote engine start transmitter three

times. The system will pause for 1 second

and then flash the parking lights and honk

the horn three times indicating that the

system is in service mode. When attempt-

ing to activate the remote start system

while in service mode, the parking lights

will flash and the horn will honk two times

and will not start.

! To disengage the service mode

Turn the ignition switch to the “ON”

position, depress and hold the brake

pedal, then press and release the “

”

button on the remote engine start trans-

mitter three times. The system will pause

for 1 second and flash the parking lights

one time indicating that the system has

exited service mode.

NOTE

When taking your vehicle in for service,

it is recommended that you inform the

service personnel that your vehicle is

equipped with a remote engine start

system.

& Remote engine start trans-

mitter programming and pro-

grammable feature option

New transmitters can be programmed to

the remote engine start system in the

event that remote engine start transmitters

are lost, stolen or damaged. The remote

engine start system also has one pro-

grammable feature that can be adjusted

for user preference.

The remote engine start system can be

programmed to either make an audible

horn chirp upon remote start activation or

not. Remote engine start transmitter pro-

gramming and feature programming can

be adjusted using the following procedure.

1. Open the driver’s door (the driver’s

door must remain opened throughout the

entire process).

2. Insert the key into the vehicle’s ignition

switch and turn to the “ON” position.

3. Locate the small black programming

button behind the fuse box cover, on the

driver’s side left under the dashboard

panel.

4. Press and hold the black programming

button for 10 to 15 seconds. The horn will

honk and the parking lights will flash three

times to indicate that the system has

entered programming mode. At this point

you can perform either action (step 5 or

step 6).

5. To program a remote transmitter:

press and release the “

” button on each

transmitter. The horn will honk and the

parking lights will flash one time to indicate

a successful transmitter learn each time

the “

” button is pressed. You can

program up to eight transmitters.

6. To toggle the Horn Confirmation chirps

ON/OFF: press and release the brake to

toggle the feature. The horn will chirp and

the parking lights will flash one time to

indicate Confirmation Horn Chirps are

“OFF”. The horn will honk and the parking

lights will flash 2 times to indicate Con-

firmation Horn Chirps are “ON”. Depres-

1 2 ... 241 242 243 244 245 246 247 248 249 250 251 ... 410 411

Comments to this Manuals

No comments