Subaru 2009 Tribeca User Manual download pdf (Page 229)

1) Training button

2. Press the training button on the

garage door o pener moto r head u nit

(which activates the “training light” on the

unit). Proceed to step 3 within 30 seconds.

3. Inside the vehicle, firmly press and

release the HomeLink® button that was

programmed in the section above. Press

and release the button a second time to

complete the programming procedure.

NOTE

Some garage door openers may re-

quire you to do the above procedure a

third time to complete the program-

ming.

4. The garage door opener should now

recognize the HomeLink® Wireless Con-

trol System and your garage door opener

should activate when the HomeLink®

button is pressed.

& Programming for entrance

gates and garage door open-

ers in Canada

1. Unplug the motor of the entrance gate

or garage door opener from the outlet.

2. Press and hold the two outside buttons

until the HomeLink® indicator light begins

to flash (after 20 seconds). Release both

buttons.

NOTE

If any of the HomeLink® buttons are

already programmed for other devices,

skip step 2 because it clears the

memory of all three buttons.

3. Hold the end of the entrance gate’s/

garage door opener’s hand-held transmit-

ter between 1 and 3 inches (25 and 76

mm) away from the HomeLink® buttons

on the driver’s sun visor, keeping the

indicator light in view.

4. Press and hold the desired

HomeLink® button.

5. Press and release (“cycle”) the hand-

held transmitter button every 2 seconds

until step 6 is complete.

6. When the indicator light flashes slowly

and then rapidly after several seconds,

release both buttons.

7. Plug the motor of the entrance gate/

garage door opener to the outlet.

8. Test your entrance gate/garage door

Interior equipment 6-19

– CONTINUED –

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 410 411

Comments to this Manuals

No comments