Subaru 2009 Tribeca User Manual download pdf (Page 363)

1) Good

2) Blown

If any lights, accessories or other electrical

controls do not operate, inspect the

corresponding fuse. If a fuse has blown,

replace it.

1. Turn the ignition switch to the “LOCK”

position and turn off all electrical acces-

sories.

2. Remove the cover.

3. Determine which fuse may be blown.

The back side of each fuse box cover and

the “Fuses and circuits” section in chapter

12 in this manual show the circuit for each

fuse.

4. Pull out the fuse with the fuse puller.

5. Inspect the fuse. I f it has blown,

replace it with a spare fuse of the same

rating.

6. If the same fuse blows again, this

indicates that its system has a problem.

Contact your SUBARU dealer for repairs.

Main fuse

Main fuse box

The main fuses are designed to melt

during an overload to prevent damage to

the wiring harness and electrical equip-

ment. Check the main fuses if any

electrical component fails to operate (ex-

cept the starter motor) and other fuses are

good. A melted main fuse must be

replaced. Use only replacements with the

same specified rating as the melted main

fuse. If a main fuse blows after it is

replaced, have the electrical system

checked by your nearest SUBARU dealer.

Maintenance and service 11-39

1 2 ... 358 359 360 361 362 363 364 365 366 367 368 ... 410 411

Comments to this Manuals

No comments