Subaru 2009 Tribeca User Manual download pdf (Page 113)

6. Push the front side (“LOCK” side) of

the power door locking switch to set the

door locks.

7. Close the door. An electronic chirp will

sound once, the turn signal lights will flash

once and the indicator lights will start

flashing rapidly. After rapid flashing for 30

seconds (standby t ime), the in dicator

lights will then flash slowly (twice approxi-

mately every 2 seconds), indicating that

the system has been armed for surveil-

lance.

NOTE

. The system can be armed even if the

engine hood, the windows and/or

moonroof are opened. Always make

sure that they are fully closed before

arming the system.

. The 30-second standby time can be

eliminated if you prefer. Have it per-

formed by your SUBARU dealer.

. The system is in the standby mode

for a 30-second period after locking the

doors with the remote transmitter. The

security indicator light will flash at

short intervals during this period.

. If any of the following actions is

done during the standby period, the

system will not switch to the surveil-

lance state.

. Doors are unlocked using the

remote transmitter.

. Any door or the rear gate is

opened.

. Ignition switch is turned to the

“ON” position.

& Disarming the system

Briefly press the “ ” button (for less than

2 seconds) on the remote transmitter. The

driver’s door will unlock, an electronic

chirp will sound twice, the turn signal

lights will flash twice and the indicator

light will turn off.

To unlock all other doors and the rear

gate, briefly press the “

” button a

second time within 5 seconds.

NOTE

If the interval between the first and

second presses of the “

” button (for

unlocking of all of the doors and the

rear gate) is extremely short, the sys-

tem may not respond.

! Emergency disarming

If you cannot disarm the system using the

transmitter (i.e. the transmitter is lost,

broken or the transmitter battery is too

weak), you can disarm the system without

using the transmitter.

The system can be disarmed if you turn

the ignition switch from the “LOCK” to the

“ON” position with a registered key.

& Valet mode

When you choose the valet mode, the

alarm system does not operate. In valet

mode, the remote transmitter is used only

for locking and unlocking the doors and

rear gate and panic activation.

To enter the valet mode, chan ge the

setting of your vehicle’s alarm system for

deactivation mode. Refer to “Activating

and deactivating the alarm system” in this

section. The security indicator light will

continue to flash once every 3 seconds

indicating that the system is in the valet

mode.

Keys and doors 2-17

– CONTINUED –

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 410 411

Comments to this Manuals

No comments