Subaru 2009 Tribeca User Manual download pdf (Page 108)

2-12 Keys and doors

6. Replace with a new battery (Type

CR1620 or equivalent) making sure to

install the new battery with the negative

(−) side facing up.

7. Put together the transmitter case by

fitting the hooks on both sides of the case.

8. Put the transmitter case in the key

head and then put together the key head.

9. Reinstall the screw on the key head.

After the battery is replaced, the trans-

mitter must be synchronized with the

remote keyless entry system’s control

unit. Press either the “

” or “ ” button

six times to synchronize the unit.

& Replacing lost transmitters

If you lose a transmitter or want to

purchase additional transmitters (up to

four can be programmed), you should re-

program all of your transmitters for secur-

ity reasons. It is recommended that you

have your dealer program all of your

transmitters into your system.

! Programming the transmitters

The remote keyless entry system i s

equipped with a special code learning

feature that allows you to program new

transmitter codes into the system or to

delete old ones. The system can learn up

to four unique transmitter codes. The four

transmitter codes may be the same or

different.

Programming transmitter codes into

system:

Key tag

Transmitter circuit board

To register a new transmitter with the

remote keyless entry system, it is neces-

sary to program the transmitter’s code

(identification number) into the system. A

tag showing the code is affixed to the key

unit, and another is affixed to the circuit

board inside the transmitter. If there is no

tag, open the transmitter case and make a

note of the eight-digit number. Program

the number into the system in accordance

with the following procedure:

1. Firmly close the doors and the rear

gate.

2. Open the driver’sdoor,sitonthe

driver’s seat, and close the door.

3. Perform the following steps within 45

seconds.

(1) Open and close the driver’s door

once.

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 410 411

Comments to this Manuals

No comments