Subaru 2009 Tribeca User Manual download pdf (Page 42)

1-18 Seat, seatbelt and SRS airbags

Retractor (ALR) mode.

When the child restraint system is re-

moved, make sure that the retractor is

restored to the Emergency Locking Re-

tractor (ELR) function by allowing the

seatbelt to retract fully.

For instructions on how to convert the

retractor to the ALR mode and restore it to

the ELR mode, refer to the “Installing child

restraint systems with A/ELR se atbelt”

section in this chapter.

& Seatbelt warning light

and chime

Your vehicle is equipped with a seatbelt

warning device at the driver’s and front

passenger’s seat.

With the ignition switch turned to the “ON”

position, this device reminds the driver

and front passenger to fasten their seat-

belts by illuminating the warning lights in

the locations indicated in the following

illustrations and sounding a chime.

Driver’s warning light

Front passenger’s warning light

! Operation

If the driver and/or front passenger have/

has not yet fastened the seatbelt(s) when

the ignition switch is turned to the “ON”

position, the seatbelt warning light(s) will

flash for 6 seconds, to warn that the

seatbelt(s) is/are unfastened. If the dri-

ver’s seatbelt is not fastened, a chime will

also sound simultaneously.

NOTE

. If the driver’s and/or front passen-

ger’s seatbelt(s) is/are still not fastened

6 seconds later, the seatbelt warning

device operates as follows according

to the vehicle speed.

. At speeds lower than approxi-

mately 9 mph (15 km/h)

The warning light(s) for unfastened

seatbel t(s) will alternate between

steady illumination and flashing at

15-second intervals. The chime will

not sound.

. At speeds higher than approxi-

mately 9 mph (15 km/h)

The warning light(s) for unfastened

seatbel t(s) will alternate between

flashing and steady illumination at

15-second intervals and the chime

will sound while the warning light(s)

is/are flashing.

. It is possible to cancel the warning

operation that follows the 6-second

warning after turning ON the ignition

switch . When the ignition switch is

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 410 411

Comments to this Manuals

No comments