Subaru 2011 Tribeca User Manual download pdf (Page 396)

Black plate (241,1)

北米Model "A3160BE-C" EDITED: 2010/ 11/ 19

3. Press and hold the hand-held trans-

mitter button. The HomeLink

®

indicator

light will flash, first slowly and then rapidly.

4. When the indicator light begins to flash

rapidly, release both buttons.

The programming for the previous device

is now erased and the new device can be

operated by pushing the HomeLink

®

button.

& Erasing HomeLink

®

button

memory

NOTE

. Performing this procedure erases

the memory of all the preprogrammed

buttons simultaneously. The memory

of individual buttons cannot be erased.

. It is recommended that upon the

sale of the vehicle, the memory of all

programmed HomeLink

®

buttons be

erased for security purposes.

1. Press and hold the two outside buttons

until the indicator light begins to flash

(after 20 seconds).

2. Release both buttons.

& In case a problem occurs

If you cannot activate a device using the

corresponding HomeLink

®

button after

programming, contact HomeLink at

www.homelink.com or call 1-800-355-

3515 for assistance.

Rear view camera (if

equipped)

A rear view camera is attached to the rear

gate. When the ignition switch is “ON” and

the select lever is set to “R”, the rear view

camera automatically displays the rear

view image behind the vehicle on the

navigation monitor or on the inside mirror.

WARNING

. Since the rear view camera uses

a wide-angle lens, the image on

the monitor is different from the

actual view in terms of distance.

. Since the range of the image on

the monitor is limited, you should

always check the rear view and

Interior equipment 6-21

– CONTINUED –

6

1 2 ... 391 392 393 394 395 396 397 398 399 400 401 ... 579 580

Comments to this Manuals

No comments