Subaru 2009 Impreza User Manual download pdf (Page 149)

3-34 Instruments and controls

& Average fuel consumption

1) U.S.-spec. models

2) Except U.S.-spec. models

This indication shows the average rate of

fuel consumption since the trip meter was

last reset.

When either of the trip meter indications is

reset, the correspond ing average fuel

consumption value is also reset.

& Turn off display of fuel con-

sumption indicator

The display of the fuel consumption

indicator can be turned off.

To turn off the display of the indicator, turn

the ignition switch to the “LOCK” position

and press the “+” button adjacent to the

information display for approximately 5

seconds. Then, the information display

and the clock displ ay will blink for 3

seconds to notify that the display of the

fuel consumption has been turned off.

To restore the indicator, once again press

the “+” button for approximately 5 sec-

onds.

NOTE

. The indicated values vary in accor-

dance with changes in the vehicle’s

running conditions. Also, the indicated

values m ay differ slightly from the

actual values and should thus be

treated only as a guide.

. When either trip meter indication is

reset, the average fuel consumption

corresponding to that trip meter indica-

tion is not shown until the vehicle has

subsequently covered a distance of 1

mile (or 1 km).

. The average fuel consumption is

calculated even while the indicator is

not displayed.

. Even if you turn off the fuel con-

sumption indicator, the fuel consump-

tion indicator will automatically turn on

when the battery voltage is discon-

nected and then reconnected for bat-

tery replacement or fuse replacement.

Light control switch

The light control switch operates when the

key is inserted into the ignition switch.

Regardless of the position of the light

control switch, the illuminated lights are

turned off when the key is removed from

the ignition switch.

NOTE

Even if the key is removed from the

ignition switch, the lights can be illu-

minated by operating the light control

switch from “OFF” to the “

” or “ ”

position. In this case, if the driver’s

door is opened, a chirp sound wi ll

inform the driver that the lights are

illuminated.

CAUTION

. Use of any lights for a long period

of time while the engine is not

running can cause the battery to

discharge.

. Before leaving the vehicle, make

sure that the light control switch

is turned to the “OFF” position. If

the vehicle is left unattended for

a long time with the light control

switch set to a position other

than “OFF”, the battery may be

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 406 407

Comments to this Manuals

No comments