Subaru 2009 Impreza User Manual download pdf (Page 106)

2-18 Keys and doors

4. Before closing the doors, lock all doors

with the inside door lock levers.

5. Close the doors. The sy stem will

automatically arm after 1 minute.

In the passive mode, the system can also

be armed with the remote transmitter or

with the power door locking switches. If

the remote transmitter or power door

locking switch is used to lock the vehicle,

arming will take place immediately regard-

less of whether or not the passive mode

has been selected.

! Disarming the system

To disarm the system, briefly press the

“

” button on the transmitter.

& Tripped sensor identification

The security indicator light flashes when

the alarm system has been triggered.

Also, the number of flashes indicates the

location of unauthorized intrusion or the

severity of impact on the vehicle.

When the ignition switch is turned to the

“ON” position, the indicator light will light

for 1 second and then flash as follows:

. When a door or rear gate (5-door) was

opened: 5 times

. When a door or the trunk (4-door) was

opened: 4 times

. When the ignition switch was turned to

the “ON” position: 3 times

. When a strong impact or multiple

impacts were sensed: twice (only vehicles

with shock sensors (dealer option))

. When a light impact was sensed: once

(only vehicles with shock sensors (dealer

option))

NOTE

Any of the above indicator light flash-

ings will recur each time the ignition

switch is turned to the “ON” position.

Rearming the alarm system cancels the

flashing.

& Shock sensors (dealer op-

tion)

The shock sensors trigger the alarm

system when they sense impacts applied

to the vehicle and when any of their

electric wires are cut. The alarm system

causes the horn to sound and the turn

signal lights to flash for a short time when

the sensed impact is weak, but it warns of

a strong impact or multiple impacts by

sounding the horn and flashing the turn

signal lights, both lasting approximately 30

seconds.

If you desire, your SUBARU dealer can

connect them and set them for activation

or deactivation.

NOTE

. The shock sensors are not always

able to sense impacts caused by break-

ing in, and cannot sense an impact that

does not cause vibration (such as

breaking the glass using a re scue

hammer).

. The shock sensors may sense vi-

bration as indicated in the following

examples and trigger the alarm system.

Select the settings of the alarm system

and shock sensors appropriately de-

pending on where you usually park

your vehicle.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 406 407

Comments to this Manuals

No comments