Subaru 2008 TRIBECA User Manual download pdf (Page 356)

11-34 Maintenance and service

1) Stopper

3. Remove the wiper blade assembly by

holding its pivot area and pushing it in the

direction shown by the arrow while de-

pressing the wiper blade stopper.

4. Install the wiper blade assembly to the

wiper arm. Make sure that it locks in place.

5. Lower the windshield wiper arm on the

passenger’s side slowly while supporting

it by hand.

6. Next, lower the windshield wiper arm

on the driver’s side slowly while support-

ing it by hand.

CAUTION

Do not let go of the wiper arm until it

touches the windshield. Letting the

wiper arm snap onto the windshield

could damage it.

& Windshield wiper blade rub-

ber

1) Metal support

1. Grasp the locked end of the blade

rubber assembly and pull it firmly until the

stoppers on the rubber are free of the

metal support.

1) Metal spines

2. If the new blade rubber is not provided

with two metal spines, remove the metal

spines from the old blade rubber and

install them in the new blade rubber.

CAUTION

Be sure to install each metal spine

so as to fit its groove completely on

the center ridge of the blade rubber.

Doing otherwise may result in dis-

location and breakage of the spine

during wiper operation.

1 2 ... 351 352 353 354 355 356 357 358 359 360 361 ... 408 409

Comments to this Manuals

No comments