Subaru 2008 TRIBECA User Manual download pdf (Page 108)

2-14 Keys and doors

NOTE

. When you finish entering the eighth

digit, an electronic tone will sound for

30 seconds.

. If the interval between one push of

the switch and the next excee ds 5

seconds, an error will occur. In this

event, perform the procedure again

beginning with part 4. If an error occurs

six times, perform the procedure again

starting with part 3.

8. Befo re the electronic tone stops

sounding, use the power door locking

switch to reenter the transmitter code

beginning with the leftmost digit.

NOTE

If you do not start entering the number

using the lock knob before the electro-

nic tone stops sounding, an error will

occur. In this event, perform the proce-

dure again beginning with part 3.

9. When you have finished entering the

code a second time, an electronic tone will

sound for 1 second and automatic door

locking and unlocking operation will take

place once to indicate complet ion of

registration, provided the code entered

the second time is identical to that entered

the first time.

NOTE

If the code entered the second time is

not identical to the code entered the

first time, an error will occur. In this

event, perform the procedure again

beginning with part 5. If an error occurs

five times, perform the procedure again

starting with part 3.

10. If you wish to program another trans-

mitter code into the system (up to four

transmitter codes can be programmed into

the system), perform the procedure begin-

ning with part 4. When you have finished

programming all of the necessary trans-

mitter codes into the system, remove the

key from the ignition switch.

11. Test every registered transmitter to

confirm correct operation.

! Deleting old transmitter codes

The control unit of the keyless entry

system has four memory locations to store

transmitter codes, giving it the ability to

operate with up to four transmitters. When

you lose a transmitter, the lost transmit-

ter’s code remains in the memory. For

security reasons, lost transmitter codes

should be deleted from the memory.

To delete old transmitter codes, program

four transmitter codes into the system. If

you have only one current transmitter,

program it four times. If you have two

current transmitters, program each one

twice. If you have three current transmit-

ters, program two of them once and the

third one twice. This process will leave

only current transmitter codes in the

system’s memory.

NOTE

Make sure no one else is operating

their keyless entry system within range

of your vehicle when programming

transmitters. If someone else were to

operate their remote transmitter while

you are programming your transmit-

ters, it is possible that their transmitter

code will be programmed into your

system, allowing them unauthorized

access to your vehicle.

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 408 409

Comments to this Manuals

No comments