Subaru 2008 TRIBECA User Manual download pdf (Page 112)

2-18 Keys and doors

position.

1) LOCK

2) ON

2. Turn the ignition switch from “ON” to

“LOCK” position and remove the key from

the ignition switch.

3. Open the doors and get out of the

vehicle.

4. Before closing the doors, lock all doors

with the inside door lock levers.

5. Close the doors. The syst em will

automatically arm after one minute.

In the passive mode, the system can also

be armed with the remote transmitter or

with the power door locking switches. If

the remote transmitter or power door

locking switch is used to lock the vehicle,

arming will take place immediately regard-

less of whether or not the passive mode

has been selected.

! Disarming the system

To disarm the system, briefly press the

“

” button on the transmitter.

& Tripped sensor identification

The security indicator light flashes when

the alarm system has been triggered.

Also, the number of flashes indicates the

location of unauthorized intrusion or the

severity of impact on the vehicle.

. When the ignition switch is turned to

the “ON” position, the indicator light will

light for 1 second and then flash as

follows:

When a door or rear gate was opened:

5 times

When the ignition switch was turned to

the “ON” position by using a key not

registered with your immobilizer sys-

tem: 3 times

Whenastrongimpactormultiple

impacts were sen sed: twice (only

vehicles with shock sensors (dealer

option))

When a light impact was sensed: once

(only vehicles with shock sensors

(dealer option))

& Shock sensors (dealer op-

tion)

The shock sensors trigger the alarm

system when they sense impacts applied

to the vehicle and when any of their

electric wires is cut. The alarm system

causes the horn to sound and the turn

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 408 409

Comments to this Manuals

No comments