Subaru 2007 Impreza WRX User Manual download pdf (Page 180)

Black plate (184,1)

北米Model "A1920BE-B" EDITED: 2006/ 9/ 19

5-22 Audio

! Displaying Sirius ID of tuner

When you act ivate Sirius, you should

have your Sirius tuner ID ready because

each tuner is identified by its unique Sirius

tuner ID.

The Sirius ID will be needed when you

activate Sirius and receive Sirius custo-

mer support.

The Sirius ID can be found on the audio

display by tuning the channel to “0”.

Turn the “TUNE/FOLDER/CH” dial (23) to

select the satellite radio channel.

! Channel selection

Turn the “TUNE/FOLDER/CH” dial (23) to

select the radio channel. Turn the tuning

dial clockwise to change the channel

upward and turn the dial counterclockwise

to change the channel downward with

each click of the dial.

! Category selection

Press the “SEEK/TRACK /CAT” button

(18) to select the category of radio

channel. Press the “

” side of the button

(18) to change the category upward and

the “

” side of the button to downward

with each press of the button.

! Channel preset

Presetting a channel with a preset button

(22) allows you to select that station in a

single operation. Up to six SR1, SR2 and

SR3 channels each may be preset.

Press one of the preset buttons for at

least 2 seconds to store the channel. The

number of the channel will flash once on

the display, and the unit produces a beep

sound at this time.

! Channel scan

Press the “SCAN” button (19) to change

the radio to the SCAN mode. In this mode,

the radio scans through the channel until a

station is found. The radio will stop at the

station for 5 seconds while displaying the

channel number, after which scanning will

continue until the entire channel has been

scanned from the low end to the high end.

Press the “SCAN” button (19) again to

cancel the SCAN mode and to stop on any

displayed station.

When the “SCAN” button is pressed for

automatic tuning, stations are only

scanned in an upward direction.

! Category mode

Press the “CAT” button (21) for at least 2

seconds to turn the category mode on. In

this mode, the radio operations (channel

selection, channel scan) are performed

only in the selected category. To cancel

the category mode, press the “CAT” button

(21) for at least 2 seconds again.

! Band selection

Push the “SAT” button (20) when the radio

is on to select SR1, SR2 or SR3 reception.

Each time this button is pressed, the band

will change in the following order:

! AUX mode

Press the “CD/AUX” button (17) to select

the “AUX mode” (when the AUX unit is

connected to the AUX terminal).

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 363 364

Comments to this Manuals

No comments